42 Options Guide RX300 S3
Replacing the processor heat sink Processors
6.3 Replacing the processor heat sink
Ê Open the server as described in section “Opening the server” on page 23.
Ê Remove the air duct over the main memory and the processors (see section
“Upgrading/replacing the main memory” on page 28).
Ê Loosen the four heat sink screws in a crossover pattern (see section
“Replacing the processor” on page 38).
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Clean the upper side of the processor using a lint-free cloth.
Ê Remove the protective cover from the new heat sink.
Ê Place the heat sink on the processor socket (see section “Replacing the
processor” on page 38).
Ê Fasten the heat sink by tightening the four screws in a crossover pattern.
Ê Reinstall the air duct over the main memory and the processors (see section
“Upgrading/replacing the main memory” on page 28).
To Next Page
Loading...
