RX300 S3 Options Guide 75
10 External serial interface
V CAUTION!
Observe the safety instructions in the chapter “Safety notes” on page 15.
10.1 Installing the external serial interface
Ê Open the server as described in the chapter “Preparation” on page 21.
I For standard configuration the external serial interface is to install with a
low profile slot cover. If the optional riser card is used, a standard slot
cover is necessary.
External serial interface in standard configuration
Figure 57: External serial cable with low-profile slot cover.
Ê Remove slot cover 5 ( see “Remove the slot cover” on page 66)
To Next Page
Loading...
