RX300 S3 Options Guide 63
Accessible drives Tape drive
Ê When pushing the drive into place pull the cables back so that they are not
pinched
Ê Lock the drive.
I The front of the drive projects approx. 5mm beyond the front of the
server.
Figure 48: Connecting USB cable to the system board
Ê Connect the power cableto the SAS backplane
Ê Connect the USB Cable to the USB7 connector on the system board.
Ê Insert the cover.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter “Completion” on page 101.
To Next Page
Loading...
