RX300 S5 Service Supplement 17
Replacement routines Preparation
4 Replacement routines
V CAUTION!
Observe the safety instructions in the chapter “Safety notes” on page 11.
4.1 Preparation
I You will find a detailed description of “Opening the server“ in the Options
Guide PRIMERGY RX300 S5.
Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the on/off
switch.
Ê Pull all power connectors out of the device.
4.1.1 Opening the server
Ê Loosen the two knurled screws and pull the server as far as possible out of
the rack.
Depending on how accessible the server is in the rack cabinet, it may make
sense to remove it from the cabinet. You will find a detailed description in the
Options Guide or the Operating Manual.
Ê Push the two locking buttons and remove the cover.
Ê Slide the cover to the rear side and remove it.
4.1.2 Removing fan box holder
I There are 2 fan box holders. We are describing only the removal of the
right side fan box holder in this section. The removal procedure of the left
one is the same.
Ê Open the server as described in the section “Opening the server” on
page 17.
Ê Remove the fan box (see Options Guide PRIMERGY RX300 S5 in chapter
„preparation“).
To Next Page
Loading...
