Fujitsu PRIMERGY RX300 S5 - Replacing USB Module

24 Service Supplement RX300 S5
Replacing USB module Replacement routines
4.3 Replacing USB module
Ê Open the server as described in the section “Opening the server” on
page 17.
Ê Remove the fan box (see Options Guide PRIMERGY RX300 S5 in chapter
„preparation“).
Ê Remove the Fan box holder on the right side behind the front panel frame.
Description see section “Removing fan box holder” on page 17.
Figure 8: Unlock the front panel frame
Ê Press the locking handle upward (1).
Ê Push the front panel frame inward (2).
2
1