34 Service Supplement RX300 S5
Replacing the SAS backplane Replacement routines
Figure 20: Removing the SAS-Backplane
Ê Hold the SAS backplane by the black handle.
Ê Unlock the SAS backplane (1) and push the SAS backplane in the direction
of the arrow (2) until it unlocks out of the locking noses and the locking
mechanism on the bottom of the server.
Ê Take the backplane out.
Ê Remove the holder from the old backplane and insert it to the new backplane
Ê Insert the new backplane.
I Make sure that the backplane is engaged in the guides.
Ê Insert the fan box holder and attach it with the captive screw.
Ê Connect the all cables to SAS backplane and route them through the fan box
holder.
Ê Engage the hard disk drives again and insert all other components.
4.6.2 Replacing the SAS backplane (8 x 2.5“)
Ê Unlock all hard disk drive modules.
I Note where each hard disk is installed. When you reinstall them make
sure they go back where they came from.
2
1
To Next Page
Loading...
