Fujitsu PRIMERGY

15
E
4AdvancedConfigurationOptions
DonotchangetheAdvancedConfigurationsettingsunlessabsolutelynecessary.
・ ResetSCSIBusatICInitialization
TheSCSIbusthatisproducedduringICinitializationafterthesystemis
turnedonorafterthehardwareisresetcanberesetto｢Enabled｣or
｢Disabled｣bythisoption.Thedefaultsettingofthisoptionis｢Enabled｣.
・ HostAdapterBIOS(ConfigurationUtilityReservesBIOSspace)
Thisoptionallowsyouto｢Enabled｣or｢Disabled｣HostAdapterBIOS.The
defaultsettingis｢Enabled｣.
Note
SomeSCSISelectutilityoptionsarenot｢Enabled｣unlessHostAdapter
BIOSisenabled.(Refertothetableof"■Defaultsettings"appearingin
thechapter"3.3ThisCardConfiguration(SCSISelectUtility),(1)
Configure/ViewHostAdapterSettings".)
WhenyoubootthesystemfromaSCSIdeviceconnectedtothiscard,besure
to｢Enabled｣HostAdapterBIOS.AllperipheralsontheSCSIbusare
controlledbythedevicedriver.IfyoudonotneedHostAdapterBIOS,
｢Disabled｣HostAdapterBIOS.
・ SupportRemovableDisksUnderBIOSasFixedDisks
Usingthisoptionallowsyoutocontrolwhatremovable-mediadrivesthiscard
supports.Thedefaultsettingis｢BootOnly｣.Thissettinghasthefollowing
options:
− BootOnly
Onlyaremovable-mediadrivespecifiedasabootdeviceisconsidereda
harddiskdrive.
− AllDisks
Allremovable-mediadrivesthatHostAdapterBIOSsupportsare
consideredharddiskdrives.
− Disabled
Noremovable-mediadrivesareconsideredharddiskdrives.Sincethese
drivesarenotcontrolledinthissituation,asoftwaredriverisrequired.