With show post command, you can check the currently enabled POST test item.
(Config)#show post
Basic POST tests............................... ON
MAC loopback test.............................. ON
PHY loopback test.............................. ON
With post command, you can control the POST test items. Tests which consume
time to run are MAC loopback test and PHY loopback test. These tests can be
skipped with the following command.
With no post command, disable the MAC loopback test.
(Config)#no post maclb
With no post command, disable the PHY loopback test.
(Config)#no post phylb
Also, you can enable only Basic POST tests with post basic command.
(Config)#post basic
With copy command, copy the settings to startup-config.
(Config)#copy system:running-config nvram:startup-config
The test items which you disabled will be skipped in the next boot. Reboot the
switch.
(Config)#reboot runtime
To Next Page
Loading...
Need help?
General
