Fujitsu ScanSnap iX500

Installing in Mac OS
This section explains how to install the software in Mac OS.
System requirements
For the latest information on requirements, please visit the ScanSnap Support Site at:
http://scansnap.fujitsu.com/g-support/en/
Operating system
(*)
OS X v 10.8 (Recommended: 10.8.1 or later)
Mac OS X v10.7 (Recommended: 10.7.4 or later)
Mac OS X v10.6 (Recommended: 10.6.8)
CPU
Intel
®
Core™2 Duo 2.4 GHz or higher (Recommended: Intel
®
Core™i5 2.5 GHz or
higher)
Memory 2 GB or more (Recommended: 4 GB or more)
Display
resolution
1024 x 768 pixels or higher
Hard disk space
Free space required to install the software bundled with the ScanSnap is as follows:
● ScanSnap Manager: 1150 MB
● CardMinder: 600 MB
● ABBYY FineReader for ScanSnap: 650 MB
● ScanSnap Online Update: 20 MB
● ABBYY FineReader Express Edition for Mac: 240 MB
● Evernote for Mac: 80 MB
USB port USB 3.0/USB 2.0/USB 1.1
* : It is recommended to apply the latest updates to the Mac OS.
ATTENTION
● If the system requirements above are not satisfied, the ScanSnap may not operate.
● Do not use the USB port on the keyboard or the monitor to connect the ScanSnap (it may not function
properly).
● Make sure to use a powered hub equipped with an AC adapter if you are using a commercially
available USB hub.
● Scanning speed will slow down in the following cases:
– The CPU or the memory does not meet the required specifications
– The version of the USB port or the USB hub is USB 1.1
● A disk space approximately three times larger than the resulting scanned file size is required when
scanning documents.
Installing in Mac OS
57