3. Move the cursor down to <Recovery and Utility> and press the [Enter] key.
4. Choose your language, if necessary. Select Recovery and Utility to proceed.
5. Three tool options appear: Diagnostics, Recovery, and Utility (refer to the
Recovery and Utility tools section below for instructions on how to use these
tools).
6. If this was successful please skip the next step and go to “Recovery and Utility
tools.”
7. If this was NOT successful, please go to the next step.
Running recovery and utility from the bootable disc
Note: If your system does not have an internal writable DVD drive, connect your
system to an external drive.
To verify/change the boot-up priority (rather than booting-up from the hard drive or an
external media drive), perform the following steps:
1. Power on your system. When the Fujitsu logo appears on the screen, press the
[F12] key.
2. Insert the bootable disc into the drive tray.
3. Highlight the CD/DVD option from the Boot menu, then press [Enter].
4. Click [OK].
5. Select CD/DVD boot mode: UEFI Mode, if applicable then press [Enter]. While the
files are being loaded from the disc, the Fujitsu logo screen will appear followed
by a progress bar at the bottom of the screen.
Recovery and utility tools
Note: Recovery and Utility tools may not be available on your system depending on
the region from which the system was shipped.
Diagnostics tool: The Diagnostics tool is designed for use by IT professionals. It is not
likely you will need to use this tool. If you should need to use this tool, perform the
following steps:
1. Press the [Diagnostics Tool] button to start the Diagnostics tool.
Fujitsu
103
To Next Page
Loading...
Need help?
General