3.2
Box Menu
Box Menu Box Menu
Box Menu
3-6
EBL 1, 2 EBL ON/OFF
When this turned on, the EBL bearing is
displayed.
Note:
In the setting [Menu] -> 2 -> 8, 9, the
relative and true bearing can be toggled
in the HD-UP and Cursor gyro modes.
The other presentation modes are true
bearing.
WATCH “Count-down”
Count-down starts from the time set by
[Menu] -> 3 -> 4, and an alarm sounds
when “0” is reached. Place the cursor on
the [WATCH] box and click the left
button, and then the counting is reset.
Clicking the [ALARM ACK] box reset
the counting is also by.
HL OFF HL OFF
Temporarily erases the heading line and
marks while pressed.
TX/STBY TX>STBY
Toggling between STBY and TX, and
ending the ARPA test.
GAIN Adjusts the sensitivity of radar receiver.
SEA AUTO>MANUAL
Allows the adjustment of sea clutter in
the MANUAL mode, and it is saved.
RAIN Allows the adjustment of the rain clutter.
TUNE AUTO>MANUAL
Allows the adjustment of tuning in the
MANUAL mode. A position of ▲
mark with respect to bar length shows
the tuned voltage value from 5 to 25 V
and the display on bar shows tuning
level.
Note:
[Menu] -> 1 -> 3
CURSOR Data
R/NM > L/L > NM/NM
(Range>L/L>X-Y-axis)
When the SET and DRIFT data is turned
off, the second cursor data is displayed.
On the IMO and A type radars, only one
cursor data is available.
When selecting R/NM, TTG is displayed
in the first cursor.
SET/ DRIFT
SET：000.0 to 359.9 deg.
DRIFT:00.0 to 19.9 kt
The SET/DRIFT is displayed when
SET/DRIFT setting in the [SPD] box
menu is turned ON.
When this is turned off, the second
cursor data is displayed except on the
IMO and A type radars.
Note:
[SPD] box menu -> 3
Cont’d
To Next Page
Loading...
