d) Temperature Source (DFF3 only)
If the DFF3 is equipped with a water temperature sensor, click the Temperature
Port pull-down menu, and choose the temperature source, MJ (NMEA0183
connector), High-frequency or Low-frequency.
IMPORTANT NOTE: The MFD8 and MFD12 cannot accept a decimal point in the
frequency fields for this setting. Therefore, certain fields in this Setup Page must be
typed using a multiplier of (x0.1). In other words, setting a frequency of 201.5 kHz must
be typed as “2015” (2015 x 0.1=201.5). Setting a frequency of 52.3 kHz must be typed
as “523” (523 x 0.1=52.3).
Note: For DFF3, set the tap setting in the network sounder after setting up all the MFDs.
For details, see the Operator’s Manual of the DFF3.
ETR 30/60 (BBFF1/3)
a) Transducer Setup:
You can choose between “Model Number” (for Furuno Transducer only) and
Manual (to manually set up the power and frequency).
IMPORTANT NOTE: The MFD8 and MFD12 cannot accept a decimal point in the
frequency fields for this setting. Therefore, certain fields in this Setup Page must be
typed using a multiplier of (x0.1). In other words, setting a frequency of 201.5 kHz must
be typed as “2015” (2015 x 0.1=201.5). Setting a frequency of 52.3 kHz must be typed
as “523” (523 x 0.1=52.3).
b) Transducer Position:
For future use.
Note: Set the tap setting in the network sounder after setting up all the MFDs. For
details, see the Operator’s Manual of your sounder
To Next Page
Loading...
