FCV1150
The FCV1150 must have version 3.01 software or higher to work in a NN3D system.
NavNet3D offers remote compatibility with the FCV1150. You will have to set up the
FCV1150 for “NavNet Mode” from the System menu (start the FCV1150 while pressing
the MENU key). Once the FCV1150 is in NavNet mode and connected to the NavNet
network, it will appear as a selection in the Installation Wizard and in the Sounder
Source menu of NN3D.
The sounder setups are done from the FCV1150 menu.
Transducer Position:
For future use.
Note: NavNet 3D offers limited control over the FCV1150. From NavNet3D, you can
only control:
- Range
- Shift
- Auto Mode (Cruising, Fishing, Manual)
- Auto Range
If you don’t have any DRS (Radar), click on Exit to finish the installation. If you have
radar, click on “Next” to continue the configuration.
To Next Page
Loading...
