40
8 SD Card Information
WARNING: DO NOT ERASE OR ALTER any of the files on your SD card outside of the “gcodes” folder. Doing so will
cause your printer to malfunction.
Your SD card is the “hard drive” of your F400. While it is removable, the card must be installed in the printer in
order for it to operate.
If the printer is powered on and the SD card is removed, you MUST press the “stop / reset” button to reboot the
printer after the SD card is reinserted. This is to re-initialize the SD card.
As long as the printer is idle, (not running a print, loading/unloading filament, etc), it is perfectly safe to remove
the SD card while the printer is powered on. Just press the “stop / reset” button after you re-insert the card.
The SD card contains 4 directories:
Gcodes: This is where you will manually copy .gcode files if you’re copying them to the SD card. Unlike
the F306, .gcode files in the root directory of the card will not show up in the files list.
Macros: This folder contains the scripts that show up in the “macros” submenu.
Sys: This folder contains the files that make your printer operate properly.
Www: This folder contains the files that make up the web page the F400 puts on your local network.
To Next Page
Loading...
