6
3 Setting Up Your F400
3.1 Please Retain All Packaging
IMPORTANT: Please retain all packaging materials (3 pieces of the box, pallet, foam endcaps). In the unlikely event
you need to send your printer back to Fusion3 for repair you will need the packaging materials. The tube can be
collapsed for relatively compact storage.
3.2 Lifting, Carrying, and Transporting
Your F400 is a 2-person lift only! It weighs 85 lb.
On the left and right faces are cutouts that function as hand-holds.
Remember this is a piece of precision equipment: do not subject it to shocks, drops, or bumps.
3.3 Finding a Suitable Surface
Your F400 will be at home on any reasonably sturdy and stable surface that:
Can support 120 lb
Is at least 31” x 30” in size
Will resist shaking and vibration during the printer’s operation
The rear face of your F400 must be at least 2 inches from any wall or obstruction, to allow adequate
ventilation.
The right face needs sufficient clearance for the power cord and for the operator to easily reach the
power switch.
Rubber feet on the bottom of the unit will prevent sliding on most surfaces
3.4 What is a Suitable Ambient Environment?
Typical office/indoor environment is preferred. 40
o
F to 85
o
F ambient temperature is recommended.
To Next Page
Loading...