61
Use paper towels and/or your part scraper to scrape the glue off and wipe the bed down. It doesn’t have to be
perfectly clean, you just want to remove most of the glue.
If you’re immediately starting another print, make sure the bed is dry before applying fresh gluestick.
9.7 Preparing the Print Bed
Use the gluesticks included with your toolkit to apply an even layer of glue to the bed.
The glue layer does not have to be thick; you do not have to push down on the gluestick as you apply it.
You do not need to cover the entire bed if you’re printing a small part.
Remember to avoid putting gluestick over the black corner square unless you know your part will overlap
those areas.
Apply fresh glue to a clean bed for every print!
For ABS, use 2 layers of glue applied at right angles. For most other materials, use a single layer of glue.
To Next Page
Loading...
