24
Note: If a print is running, the upload option will be locked out until the print is done. This is for performance
reasons.
6.2.4 Other Tabs
The other tabs such as the Gcode console, Macros, and Settings tabs are not used in normal use.
6.3 Changing the Web Interface Configuration
The following parameters can be adjusted by the end user if needed. To adjust these you will need to open and
edit the /sys/config.g file on your SD card. See section 8 for more information on the SD card file system.
Website name
Login password
Printer MAC address
Assign printer a static IP address
6.3.1 Website Name
If you have multiple F400s on your network, you will need to assign each one a unique name to prevent conflicts.
To change the website name, locate the line in config.g that begins with “M550 PFusion3 F400”.
The characters after the “P” are the name of your printer and will also be used as the web address for the web
interface.
6.3.2 Login Password
To change the login password, locate the line that begins with “M551 Pfusion3”.
The characters after the “P” are the login password.
To Next Page
Loading...
