55
If you had to make large changes (more than 1 full turn) to any corner, you may want to check all the corners a
second time to make fine adjustments.
Finally, select the “Disable Motors” macro when you are done.
9.4 Loading Filament
Your F400’s filament handling system is designed to accommodate a wide range of filament spool sizes from 1lb
with a 0.5” center hole, all the way up to 5kg rolls.
First, insert the filament dowel through the center hole of the spool.
Orient the spool so the filament pays off the front side (or underneath) of the spool.
To Next Page
Loading...
