76
Use a light finger touch on the cables to ensure they are not slack. A wide range of tension is acceptable; as long
as the cables are not actually loose they are fine.
If you print a lot of high temperature materials, you may find the cables are slightly loose at room temperature.
11.6.2 Check X Axis Square
The angle the X axis makes relative to the Y axis depends on the relative tension in the two drive cables. This
makes it easy to adjust the square if needed.
Here at Fusion3, we use a 12 inch carpenter’s square with 2.5 inches cut out of the vertex as a tool to check the
square of the X axis. This is faster than measuring.
To Next Page
Loading...
