FUTABA 12FG - Page 108

108
<Functions of Model Menu (Helicopter Functions)>
Normal Curve Idle-up 1 Curve Idle-up 2 Curve Hold Curve
Ɣ3LWFK&XUYH([DPSOH
ŏ*URXS6LQJOHLWHP:KHQ\RXDOVRZDQWWR
LQSXWWKHVDPHVHWWLQJFRQWHQWVDWRWKHU
FRQGLWLRQVSHUIRUPVHWWLQJLQWKHJURXS
PRGH,QWKLVFDVHWKHVDPHFRQWHQWVDUH
LQSXWWRWKHRWKHUFRQGLWLRQVVHWLQWKHJURXS
PRGH:KHQ\RXZDQWWRVHWHDFKFRQGLWLRQ
LQGHSHQGHQWO\VHOHFWWKHVLQJOHPRGH
LQLWLDOVHWWLQJ2WKHUFRQGLWLRQVFDQEHVHW
LQGHSHQGHQWO\
Setting method
ŏ3LWWULPFRS\+RYHUKLJKORZ
 7KHSLWFKWULPRSHUDWLQJSRVLWLRQFDQEH
FRSLHGWRWKHSLWFKFXUYH
 0RYHWKHFXUVRUWRWKH>&23<@LWHPDQG
SXVKWKH(',7EXWWRQ
 $IWHUFRS\LQJUHWXUQWKHSLWFKWULPWRWKH
FHQWHUWRFDOOWKHODVWRSHUDWLQJSRVLWLRQ
The screens shown below are curves created
by entering the pitch rate at low, center, and high
side (3 points or 5 points) at each condition. When
DFWXDOO\FUHDWLQJDFXUYHLQSXWWKHUDWHVSHFL¿HGDW
the fuselage (or the reference value).
*For a description of the curve setting method, see the
description at the back of this manual.
Curve setting examples
(Continued on next page)
Pitch Trim (Hovering pitch, high pitch, low pitch)
The hovering pitch, low pitch, and high pitch trim setup screen can be called from the PIT Curve setup
screen.
ŏ+RYHULQJSLWFK
WULPVHWWLQJ
ŏ/RZ+LJKSLWFK
WULPVHWWLQJ