28
<Functions of System Menu>
TRAINER
7UDLQHUV\VWHPVWDUWLQJDQGVHWWLQJ
The Trainer function makes it possible for the 
instructor to choose which functions and channels 
are to be used for instruction, making it possible to 
match the training ability to the student's skill level. 
Two transmitters must be connected by an optional 
Trainer Cord, and the Instructor's transmitter should 
be programmed for trainer operation, as described 
below.
When the Instructor activates the trainer switch, 
the student has control of the aircraft (if MIX or 
FUNC mode is turned on, the Instructor can make 
corrections while the student has control). When 
the switch is released the Instructor regains control. 
This is very useful if the student gets the aircraft 
into an undesirable situation.
NOTE: This trainer system can be used in the 
following manner;
1. With the T12FG transmitter and a conventional 
transmitter, if the channel order is different. It 
is necessary to match the channel order in 
the Function setting screen when connecting 
it with other than a T12FG.
2. When the T12FG is used as the Teacher, set the 
modulation mode of the student’s transmitter 
to PPM. If being used as the student, set the 
T12FG to the modulation mode specified by 
the Instructor's transmitter. When the Instructor's 
transmitter is a T14MZ, 12Z, 12FG, T9Z, T9C or 
T7C transmitter, it should be switched to PPM 
mode.
3. Be sure that all channels work correctly in 
ERWKWUDQVPLWWHUVEHIRUHÁ\LQJ
T12FG special trainer cable
Use the T12FG special trainer cable when using the T12FG transmitter at the trainer 
function instructor side. Operation may not be normal with a conventional trainer cable.
*When the T12FG transmitter is used at the student side when the instructor side transmitter is not a T12FG, a 
conventional trainer cable may be used.
,QVWUXFWRU VWXGHQW 7UDLQHUFDEOH
7)*
7(;7(;7&7& 7)*VSHFLDOWUDLQHUFDEOH
7=70=); &RQYHQWLRQDOWUDLQHUFDEOH5HFW5HFW
79 &RQYHQWLRQDOWUDLQHUFDEOH5HFW5RXQG
7;7878DQG7=DUHQRWDSSOLFDEOH
2WKHUWKDQ
7)*
7)*
&RQYHQWLRQDOWUDLQHUFDEOH5HFW5HFWRU
&RQYHQWLRQDOWUDLQHUFDEOH5HFW5RXQG
*The direction that the T12FG special trainer cable connects is fixed. Connect the 
instructor side connector of the cable to the instructor T12FG and connect the student side 
connector to the student transmitter. If the cable is connected in reverse, the student side 
power will not be turned on even if the instructor side power is set to ON.
*If the instructor side T12FG trainer function is not enabled, the student side power will 
not be turned on even if the connection direction is correct.