106
<Functions of Model Menu (Helicopter Functions)>
S1 button
EDIT button
EDIT dial
ŏ3XVKWKHS1EXWWRQ IRU
VHFRQGWR UHWXUQWR WKH
KRPHVFUHHQ
ŏ7XUQWKHEDITGLDOWR
PRYHRQWKHVFUHHQ
ŏ6HOHFWWKHIXQFWLRQ
QDPHDQG UHWXUQWR WKH
SUHFHGLQJVFUHHQ E\
SXVKLQJWKHEDITEXWWRQ
MODEL MENU (HELICOPTER)
This section contains information on the
commands that apply to helicopters only. For
instructions on Airplanes and Sailplanes, refer to
the sections pertaining to those aircraft.
Use the Model Type function in the Linkage
Menu to select the swash type matched to the
fuselage beforehand.
Also, add flight conditions at the Condition
Select screen if necessary before setting the model
data at each function. (Up to 8 conditions can be
used)
The AFR function, Dual rate function and other
functions common to all model types, are described
in a separate section.
Model Menu functions (helicopter) list
PIT CURVE:$GMXVWVUHVSRQVHLQGLIIHUHQWÀLJKWFRQGLWLRQV
THR CURVE: Throttle curve and hovering trim adjustment
ACCELERATION: Allows a brief "overload" in response to sudden throttle and pitch commands
THR HOLD: Moves the throttle to idle during autorotation
SWASH MIX: Compensates for each control response
THROTTLE MIX: Compensates for power loss when cyclic applied
PIT to NEEDLE:$GMXVWVUHVSRQVHFXUYHLQGLIIHUHQWÀLJKWFRQGLWLRQV
PIT to RUD: Handles torque changes from pitch angle inputs
GYRO: Used to switch gyro sensitivity
GOVERNOR: Used to switch RPM of the helicopter’s head
To activate/deactivate Condition Hold:
0RYHWKHFXUVRUWR>&21'+2/'@
6HWWKHWKURWWOHVWLFNORZHUWKDQ
WKHSRLQWDQGSXVKWKH(',7
EXWWRQWRDFWLYDWHGHDFWLYDWHWKH
FRQGLWLRQKROGIXQFWLRQ
*Refer to for condition hold function details.
*Condition hold operation is displayed.
ŏ6HOHFWWKH>02'(/@DWWKHKRPHVFUHHQ
DQGFDOOWKHPRGHOPHQXVKRZQEHORZE\
SXVKLQJWKH(',7EXWWRQ
ŏ8VHWKH(',7GLDOWRVHOHFWWKHIXQFWLRQ\RX
ZDQWWRVHWDQGFDOOWKHVHWXSVFUHHQE\
SXVKLQJWKH(',7EXWWRQ
ŏ3XVKWKH S1EXWWRQ WR
FDOOQH[WSDJH
To Next Page
Loading...
