FUTABA 12FG - FUNCTIONS OF LINKAGE MENU; Linkage Menu functions table

47
<Functions of Linkage Menu>
S1 button
EDIT button
EDIT dial
ŏ3XVKWKHS1EXWWRQ IRU
VHFRQGWR UHWXUQWR WKH
KRPHVFUHHQ
ŏ7XUQWKHEDITGLDOWR
PRYHRQWKHVFUHHQ
ŏ6HOHFWWKH>/,1.$*(
0(18@DQG UHWXUQWR WKH
KRPHVFUHHQ E\SXVKLQJ
WKHEDITEXWWRQ
FUNCTIONS OF LINKAGE MENU
The Linkage Menu is made up of functions
which perform model addition, model type
selection, frequency setting, end point setting, and
other model basic settings.
The functions which can be selected depend on
the model type. A typical menu screen is shown
below.
*The display screen is an example. The screen
depends on the model type.
Linkage Menu functions table
[SERVO MONITOR]: Displays the servo test and operation position
[MODEL SELECT]: Model addition, call, deletion, copy, model name setting
[MODEL TYPE]: Model type, wing type, swash type, etc. selection
[FREQUENCY]: Frequency selection, modulation mode selection, receiver ID setting
[FUNCTION]: Channel assignment of each function can be changed
[SUB-TRIM]: Adjusts the neutral position of each servo
[SERVO-REVERSE]: Servo direction reversal
[FAIL SAFE]: Fail safe function and battery fail safe function setting (PCM-G3/PCM1024 only)
[END POINT]: Servo basic rudder adjustment and limit setting
[THROTTLE CUT]: Stops the engine safely and easily (airplane and helicopter only)
[IDLE DOWN]: Lowers the idle speed of the engine (airplane and helicopter only)
>6:$6+5,1*@/LPLWVWKHVZDVKSODWHWUDYHOWRZLWKLQD¿[HGUDQJHKHOLFRSWHURQO\
[SWASH]: Swash AFR and linkage correction function (helicopter only)
[TIMER]: Timer setting
[T1-T6 SETTING]: Control step amount and mode selection of the digital trim
[DATA RESET]: Model memory set data reset (by item)
[COND. HOLD]: Condition hold function (helicopter only)
ŏ6HOHFW>/,1.$*(@DWWKHKRPHVFUHHQDQGFDOO
WKHOLQNDJHPHQXVKRZQEHORZE\SXVKLQJ
WKH(',7EXWWRQ
ŏ8VHWKH(',7GLDOWRVHOHFWWKHIXQFWLRQ\RX
ZDQWWRVHWDQGFDOOWKHVHWXSVFUHHQE\
SXVKLQJWKH(',7EXWWRQ
To activate/deactivate Condition Hold:
+HOLFRSWHUW\SHRQO\
0RYHWKHFXUVRUWR>&21'+2/'@
6HWWKHWKURWWOHVWLFNORZHUWKDQ
WKHSRLQWDQGSXVKWKH(',7
EXWWRQWRDFWLYDWHGHDFWLYDWHWKH
FRQGLWLRQKROGIXQFWLRQ
*Refer to condition hold function details.
*Condition hold operation is displayed.
ŏ3XVKWKH S1EXWWRQ WR
FDOOQH[WSDJH