FUTABA 12FG - Timer

67
<Functions of Linkage Menu>
S1 button
EDIT button
EDIT dial
ŏ3XVKWKHS1EXWWRQ IRU
VHFRQGWR UHWXUQWR WKH
KRPHVFUHHQ
ŏ7XUQWKHEDITGLDOWR
PRYHRQWKHVFUHHQ
ŏ6HOHFWWKHIXQFWLRQ
QDPHDQG UHWXUQWR WKH
SUHFHGLQJVFUHHQ E\
SXVKLQJWKHEDITEXWWRQ
TIMER
7LPHUVHWWLQJ
The Timer function may be set for any desired time,
LHHQJLQHUXQWLPHVSHFL¿HGWLPHVIRUFRPSHWLWLRQV
etc. Two independent timers are provided for your use.
The timers are stored independently with each model,
meaning that when you switch between model setups,
the timer associated with the new model is brought up
automatically.
The timers may be set to start and stop from the
motion of any switch or stick. You may set the ON and
OFF directions freely. Each timer has a capacity of up
to 59 minutes 59 seconds.
Timer setting
*Perform the following settings after using the EDIT dial to
move the cursor to the item you want to set.
8SWLPHUGRZQWLPHUVHWWLQJ
 0RYHWKHFXUVRUWRWKH>02'(@LWHPDQG
SXVKWKH(',7EXWWRQWRVZLWFKWRWKHGDWD
LQSXWPRGH
 6HOHFWWKHPRGHE\PRYLQJWKH(',7GLDOWR
WKHOHIWRUULJKWDQGSXVKWKH(',7EXWWRQ
 >83@8SWLPHU
 >'2:1@'RZQWLPHU
7LPHUWLPHVHWWLQJ
 0RYHWKHFXUVRUWRWKH>@>@LWHPDQG
SXVKWKH(',7EXWWRQWRVZLWFKWRWKHGDWD
LQSXWPRGH
 6HWWKHWLPHE\WXUQLQJWKH(',7GLDOWRWKHOHIW
RUULJKW
 >@>@>PLQ@>VHF@
 3XVKWKH(',7EXWWRQWRHQGDGMXVWPHQWDQG
UHWXUQWRWKHFXUVROPRYHPRGH
6ZLWFKVHWWLQJ
 0RYHWKHFXUVRUWRWKHLWHPRIWKHVZLWFK
\RXZDQWWRVHWFDOOWKHVZLWFKVHWXSVFUHHQ
E\SXVKLQJWKH(',7EXWWRQDQGVHOHFWWKH
Each timer may be set for count-down or count
up operation with a target time.
If a target time is set and the timer reaches the set
time, a buzzer sound for each count is generated.
Countdown timers sound one short beep during the
last twenty seconds and two short beeps during the
last ten seconds before reaching the target, then a long
tone at the target time, and continue counting with
displaying a minus (-) sign. Count-up timers also beep
the last twenty and ten seconds, beep the target time,
and keep counting upwards until shut down.
VZLWFKDQG21GLUHFWLRQ
[For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.]
 >5(6(76:@5HVHWVZLWFK
 >67$576:@6WDUWVZLWFK
 >67236:@6WRSVZLWFK
Timer operation
ŏ 7LPHUDQG7LPHUDUHVWDUWHGVWRSSHGE\
SUHVHOHFWHGVWDUWVWRSVZLWFK
ŏ 7RUHVHWDWLPHURSHUDWHWKHSUHVHOHFWHG
UHVHWVZLWFKRUPRYHWKHFXUVRUWRWKH>5(6(7@
GLVSOD\RQWKHWLPHUVFUHHQDQGSXVKWKH(',7
EXWWRQ
ŏ 6HOHFW>7,0(5@DWWKHOLQNDJHPHQXDQGFDOOWKHVHWXS
VFUHHQVKRZQEHORZE\SXVKLQJWKH(',7EXWWRQ