111
<Functions of Model Menu (Helicopter Functions)>
Normal Curve Idle-up 1 Curve Idle-up 2 Curve
Ɣ7KURWWOH&XUYH([DPSOH
The curves shown below are created by using
the point curve type and inputting the data of the
5 points 0% (low side), 25%, 50% (center), 75%,
100% (high) side at each condition. They are
created by reducing the number points of the line
to 5. When actually creating a curve, enter the data
VSHFL¿HGSHUWKHDLUFUDIWRUWKHUHIHUHQFHYDOXH
*For a description of the curve creation method, see the
description at the back of this manual.
Curve setting examples
Throttle Hover trim
The Throttle Hover trim setup screen can be called from the THR Curve setup screen.
The Throttle Hover function trims the throttle
near the hovering point. Normally, use it with
hovering conditions. Changes in rotor speed
accompanying changes in the temperature,
humidity, and other flight conditions can be
trimmed. Adjust the throttle so that rotor rotation is
most stable. More delicate trimming is also possible
by using this function along with the Hover Pitch
function.
Setting method
ŏ:KHQXVLQJWKHKRYHULQJQRUPDOFRQGLWLRQ
RQO\VZLWFKWKHJURXSPRGHWRWKHVLQJOH
PRGHLQLWLDOVHWWLQJDQGPDNHWKHVHWWLQJV
ŏ6HWWKHIXQFWLRQWR$&7>21@
ŏ6HOHFWWKHDGMXVWPHQWNQRE
6HOHFWLRQH[DPSOH5'
ŏ7KHWULPRSHUDWLRQPRGH0RGH&750
1250FDQEHVHOHFWHG
CTRM mode:0D[LPXPUDWHRIFKDQJH
QHDUFHQWHUE\FHQWHUWULPRSHUDWLRQ
UHFRPPHQGHG
NORM mode: 1RUPDOWULPKRUL]RQWDO
PRYHPHQWWULPRSHUDWLRQ
ŏ7ULPDGMXVWPHQWUDQJH5DQJHVHWWLQJ
:KHQWKHYDOXHLVPDGHVPDOOWULPDFWVRQO\
QHDUWKHFHQWHU
ŏ7KHWULPUDWHFDQEHDGMXVWHGDQGWKH
RSHUDWLRQGLUHFWLRQFDQEHVHW
ŏ6HWVWKHGLDOXVHG
To Next Page
Loading...
Need help?
General
