FUTABA 12FG - Page 127

127
<Data>
FUTABA CORPORATION Phone: (043) 296-5118 Facsimile: (043) 296-5124
Makuhari Techno Garden Bldg., B6F 1-3 Nakase, Mihama-ku, Chiba 261-8555, Japan
©FUTABA CORPORATION 2007, 04 (1)
Logic mode
AND: When both switches are ON, the
condition is ON.
OR: When either switche is ON, the
condition is ON.
EOR: When the two switches are in different
states, the condition is ON.
Switch mode selection
1. Move the cursor to the [MODE] item and
push the EDIT button to switch to the data
input mode.
2. Turn the EDIT dial to the left and select the
[LOGIC].
*[LOGIC] display blinks.
3. Push the EDIT button to change to the logic
switch mode.
(Logic switch setting screen)
Swich selection
1. Select the switch A and B. (Refer to the
description at the previous page.)
Logic mode selection
1. Move the cursor to the [LOGIC] item and
push the EDIT button to switch to the data
input mode.
2. Turn the EDIT dial to the left or right and
select the logic mode.
*The mode display blinks.
3. Push the EDIT button to change to the logic
mode.
4. To return to the preceeding screen, move
the cursor to the [SWITCH] at the top of the
screen and push the EDIT button.
Logic switch (Condition Select function only)
The logic switch function lets you turn operation on and off by combining two switches. For instance,
the condition is activated when 2 switches are turned on.