FUTABA 12FG - Page 30

30
<Functions of System Menu>
*Use the EDIT dial to move the cursor to the "MODE" item
of the channel you want to change and push the EDIT button
to switch to the data input mode and change the mode by
turning the EDIT dial to the left or right. The display blinks.
Press the EDIT button to change the mode.
 12507KHPRGHOLVFRQWUROOHGE\VLJQDOV
IURPWKHVWXGHQWWUDQVPLWWHU
 0,;PRGH7KHPRGHOLVFRQWUROOHGE\
VLJQDOVIURPWKHWHDFKHUDQGVWXGHQW
WUDQVPLWWHUV5HVHWWKHVWXGHQWVPRGHOGDWD
WRWKHGHIDXOWFRQGLWLRQ
 )81&PRGHIXQFWLRQPRGH
 7KHPRGHOLVFRQWUROOHGE\VLJQDOVIURP
WKHVWXGHQWWUDQVPLWWHUZLWKWKHWHDFKHU
$)5VHWWLQJ5HVHWWKHVWXGHQWVPRGHOGDWD
WRWKHGHIDXOWFRQGLWLRQ
 2))2QO\WKHWHDFKHUVLGHRSHUDWHV
*The setting above allows setting of the servo throw relative
to the amount of student side operation when [MIX] or
[FUNC] was selected.
 :KHQFKDQJLQJWKHUDWHXVHWKH(',7GLDO
WRPRYHWKHFXUVRUWRWKH>5$7(@LWHPRIWKH
FKDQQHO\RXZDQWWRFKDQJHDQGXVHWKH
(',7GLDOWRDGMXVWWKHUDWH
 6HWWLQJUDQJHa
 ,QLWLDOYDOXH
 3XVKWKH(',7EXWWRQWRHQGDGMXVWPHQWDQG
UHWXUQWRWKHFXUVRUPRYHPRGH
*When the EDIT button is pushed for 1 second, the rate is
reset to the initial value.
6HWWKHVZLWFKRIHDFKFKDQQHO
*When setting the switch at each channel, use the EDIT
dial to move to the "SW" item of the channel you want to
change, call the switch setup screen by pushing the EDIT
button, and select the switch.
 $OZD\V21
 6$a6+7KHVZLWFKZKLFKHQDEOHVVWXGHQW
VLGHRSHUDWLRQFDQEHVHOHFWHG6HH6ZLWFK
VHOHFWLRQPHWKRGDWWKHHQGRIWKLVPDQXDO
IRUVHOHFWLRQPHWKRGGHWDLOV