FUTABA 12FG - Page 58

58
<Functions of Linkage Menu>
S1 button
EDIT button
EDIT dial
ŏ3XVKWKHS1EXWWRQ IRU
VHFRQGWR UHWXUQWR WKH
KRPHVFUHHQ
ŏ7XUQWKHEDITGLDOWR
PRYHRQWKHVFUHHQ
ŏ6HOHFWWKHIXQFWLRQ
QDPHDQG UHWXUQWR WKH
SUHFHGLQJVFUHHQ E\
SXVKLQJWKHEDITEXWWRQ
SUB-TRIM
6HWWLQJRIQHXWUDOSRVLWLRQRIHDFKVHUYR
(The display screen is an example. The screen
depends on the model type.)
The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
Sub trim adjustment
8VHWKH(',7GLDOWRPRYHWKHFXUVRUWRWKH
FKDQQHO\RXZDQWWRDGMXVWDQGSXVKWKH
(',7EXWWRQWRVZLWFKWRWKHGDWDLQSXWPRGH
$GMXVWE\WXUQLQJWKH(',7GLDO
 ,QLWLDOYDOXH
 $GMXVWPHQWUDQJHaVWHSV
(When the EDIT button is pushed for 1 second, sub trim is
reset to the initial value.)
*Before sub trim adjustment, adjustment of the linkage so that
control surfaces need not use sub trim as much as possible is
very important.
5HSHDWWKLVSURFHGXUHIRUHDFKFKDQQHO
ŏ6HOHFW>68%75,0@DWWKHOLQNDJHPHQXDQGFDOOWKH
VHWXSVFUHHQVKRZQEHORZE\SXVKLQJWKH(',7
EXWWRQ
ŏ3XVKWKH S1EXWWRQ WR
FDOOQH[WSDJH