Changing the wheel position
The wheel position can be offset by using the
accessory APA wheel position offset adapter.
(See page 24 for the modication method.)
Angle can be adjusted
The angle can be nely adjusted by adjusting the steering wheel unit installation. (See
the modication method on the next page for the adjustment details.)
The operating angle of the wheel can be adjusted.
The operating angle of the wheel can be changed from 34 deg to 32 deg by installing
the 32 deg wheel adjuster. (See "Removing the steering wheel unit" below for the re-
placement procedure.
If you install the 32 deg wheel adapter, be sure to adjust the scale of the steering
channel accordingly by using the "Adjuster Function"
(p.128).
Modifying for left-hand use
The wheel section left and right installa-
tion direction can be reversed.
(See page 26 for the modication method.)
Removing the steering wheel unit
• Obtain 2.0 and 2.5mm hex wrenchs.
1
Hold the wheel and remove the
screw.
(Using a 2.5 mm hex wrench.)
Steering wheel
mounting screw
Unit mounting screws
2
Pull off the wheel and wheel
adapter.
Since the wheel adapter is 34 deg
as standard, install the 32 deg
wheel adapter at final installation.
3
Remove the 3 steering wheel unit
mounting screws.
(Using a 2.0 mm hex wrench.)
Wheel
Wheel adapter
To Next Page
Loading...
