4
Remove the steering wheel unit.
•Be careful not to stretch the wiring.
5
Disconnect the steering wheel
unit connector.
Installing the accessory APA steering wheel offset adapter
1
The steering wheel unit connector
through the adapter.
• Obtain 2.0 and 2.5mm hex wrenchs..
• Install the steering wheel unit, removed as described on the preceding page, as follows:
• The length of the screws used at each part differs .When reassembling the steering wheel unit, always use the
original screws.
Wheel unit
2
Install the steering wheel unit us-
ing the 3 mounting screws.
(Using a 2.0 mm hex wrench.)
Adapter APA
3
Connect the steering wheel unit
connector.
(Pay close attention to the direc-
tion of the connector.)
To Next Page
Loading...
