Grip rubber
Hook
Hook mounting screw
Hook
A hook can be installed to the T4PKSR, as required.
The hook is in the hook and APA mounting screws bag supplied with the set.
• Obtain a 2.5mm hex wrenchs.
• Pull up the grip rubber.
2
Pull out the grip rubber in the arrow
direction.
3
There is a mounting nut inside the
transmitter. Install the hook at the
position shown in the figure using
the accessory screw w/washer.
(Using a 2.5 mm hex wrench.)
1
Pull up the bottom of the grip rub-
ber as shown in the figure.
4
Return the grip rubber to its original
position.
Installing the accessory neck strap hook
To Next Page
Loading...
