Modifying for left-hand use
1
Remove the wheel section rear
cover .
• The rear cover can be easily removed by in-
serting a coin, etc. into the slot at the bottom
of the rear cover.
• Obtain 2.0 and 2.5mm hex wrenchs.
• Install the steering wheel unit removed as described on the preceding page as follows:
2
Push in the disconnected connector
so that it can be connected at the
opposite side.
3
At the opposite side, connect the
steering wheel unit connector and
Install the steering wheel unit,
steering wheel cover, and wheel to
their original positions.
• At this time, be sure that the wiring is not
pinched between the wheel unit and trans-
mitter.
Stow the surplus wiring here.
To Next Page
Loading...
