FUTABA 4PK-2.4G SuperR - Page 71

ABP
(Amount of brake return)
ABP
Servo travel
CYC
Servo travel
CYC (Cycle)
TGP
Servo travel
TGP
(Trigger point)
TGP
Brake side
Neutral
71
Function
A.B.S Function "A.B.S"
1
(Function ON/OFF)
Select the setting item "MODE" by (JOG) button up, down,
left or right operation. Set the function to the active state by
pressing the (+) or (-) button.
"INH(OFF)" :Function OFF
"ACT(ON)" :Function ON
"ACT(OFF)" :Switch OFF when setting switches
2
(Brake return amount adjustment)
Select the setting item "ABP"
by (JOG) button up, down,
left or right operation. Use
the (+) or (-) button to adjust
the return amount.
"0" :No return
"50" :Return to the 50% position of the brake operation amount
"100" :Return to the neutral position.
3
(Delay amount setup)
Select the setting item "DLY" by (JOG) button up, down, left
or right operation. Use the (+) or (-) button to adjust the delay
amount.
"0" :A.B.S. function performed without any delay
"50" :A.B.S function performed after an approximate 0.7 sec delay.
"100" :A.B.S. function performed after an approximate 1.7 secs delay.
4
(Cycle speed adjustment)
Select setting item "CYC" by
(JOG) button up, down, left
or right operation. Use the
(+) or (-) button to adjust the
pulse speed (cycle).
- The smaller the set value, the faster the pulse speed.
5
(Trigger point setup)
Select setting item "TGP" by
(JOG) button up, down, left
or right operation. Use the
(+) or (-) button to adjust the
operation point.
- Sets the throttle trigger position
at which the A.B.S. function is
performed. The number is the %
display with the full brake position made 100.
A.B.S function adjustment
A.B.S Function "A.B.S"
- Brake return amount (ABP) is
influenced by the "EXP" rate
on the brake side.
Delay amount (DLY)
0 ~ 100
Initial value: 0
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Brake return amount (ABP)
0 ~ 50 ~ 100
Initial value: 50
Function ON/OFF (MODE)
INH(OFF), ACT(ON), ACT(OFF)
Setup item selection
- Select by (JOG) button up,
down, left or right operation.
Cycle speed (CYC)
1 ~ 30
Initial value: 10
Trigger point (TGP)
10 ~ 100
Initial value: 30