FUTABA 4PK-2.4G SuperR - Page 95

95
Function
Special Mixes "S-MIX" (CPS MIX)
1
Control system setup)
Operate the (JOG) button up and down and select the set-
ting item "CTRL".
Press the (+) or (-) button and select the function.
"INH" : Function OFF
"CH4 FUNC" : ON/OFF by switch set at the 4th CH
"STRNT" : ON at steering neutral
"STREND" : ON at both sides of steering
"THRNT" : ON at throttle neutral
"THR FWD" : ON at throttle forward side
"THRBRK" : ON at throttle back (brake) side
"THNT+BK" : ON at throttle neutral and back (brake) sides
2
(ON/OFF switching position selection)
Operate the (JOG) button up and down and select the set-
ting item "POSI".
Press the (+) or (-) button and select the ON/OFF position.
Since the ON/OFF state is dis-
played at the right side of the
setting item "CTRL", setting can
be confirmed while operating
the function to be controlled (for
example, throttle).
3
(ON/OFF type setup)
Operate the (JOG) button up and down and select the set-
ting item "TYPE".
Press the (+) or (-) button and select the type of LED lighting.
Normal ON/Off type or ashing can be selected.
"NORMAL" : Normal ON/OFF type
“FLASH" : Flashing display
4
(Flashing cycle setting)
When ashing type "FLASH" was selected at the setting item
"TYPE" the ashing speed (cycle) can be set.
Operate the (JOG) button up and down and select the set-
ting item "CYCL".
Press the (+) or (-) button and select the ashing speed (cy-
cle).
5
To end setting, return to the opening screen by pressing the
(END) button three times (for direct selection, press the (END)
button once)
*Shows the ON/OFF state
ON/OFF Position (POSI)
5 ~ 95
Initial value: 50