Abbreviation used on setup screen
Function name, etc
PRESET Start function /Preset (Engine cut)
NT-BRAKE Neutral brake function ON/OFF
A.B.S.CH2 A.B.S function (2CH)ON/OFF
A.B.S.CH3,CH4 A.B.S function (3CH,4CH)ON/OFF
2ND COND 2nd condition function ON/OFF
IDLE-UP Idle up function ON/OFF
PROG MIX1 Program mixing1 function ON/OFF
PROG MIX2 Program mixing2 functionON/OFF
GYRO TYPE Switching GYRO mode
CH3 channel 3
CH4 channel 4
LAP STAR
Timer function start (SW3 not possible)
LAP RESET
Timer function reset (SW3 not possible)
4WS MIX 4WS mixing type select
OFF Not used
Set table functions
(SW1/SW2/SW3)
PS3
PS1
PS2
Function Select Switch "SWTCH"
When the set SW is operated in
the opening screen state, the 4WS
mode is displayed here for about 2
seconds.
When push switch (PS1,PS2,PS3) is operated in the opening screen state, the state of the
function is displayed in the upper-right corner for about one or two seconds.
Example :4WS Mixes
To Next Page
Loading...
