4. LED display mode [default: ON]
It selects the display mode of the LED on the gyro
sensor. The LED is light at ON setting, turned off
by Off setting for power saving. The mode can be
changed by pushing the data + or – key.
5. Operation mode [default: Gyro+Gov]
It sets the operation mode of the GY701. Set to “Gov-
ernor” when the gyro sensor is not installed and set
“Gyro” when the governor sensor is not installed. Set
“Gyro+Gov” when the both gyro and governor sensor
are installed. Mode is changed by pushing the data +
or – key. The home screen is changed after changed
the operation mode. The “SensorER” is displayed
when the gyro sensor is not installed and the opera-
tion mode is set “Gyro” or “Gyro+Gov” mode. Push
any key to escape this display and set the operation
mode is to be “Governor”.
When the operation mode is changed, it must be
needed the reboot the GY701. During the operation,
it is not allowed to change the operation mode.
To Next Page
Loading...
