(5) Stick switch
[default: 30%]
The governor can be activated by throttle stick
position. Move the throttle stick to be on position
and push SET key, the on point is memorized.
When push the RSET key, the function is inhib-
ited. When the governor on/off switch is inhib-
ited, the stick switch is automatically turned on.
(4) Servo selection
[default: Analog]
Select the throttle servo type. Digital servo is
the best for the response. The type is changed
by pushing data + or – key.
When governor turned on and off by transmit-
ter throttle stick
The data is set so that the governor can be
turned on and off with the transmitter throttle
stick. The following describes this operation.
WARNING
This parameter must match the type of ser-
vo you are using. Incorrect setting may damage
the GY701 or the servo, possibly resulting in a
loss of control during flight.
• Throttle stick set at least the set point from
slow side and engine running at 60% or more
of set speed
ON
• Throttle stick held at the set point or more from
slow side
Remains ON
• Throttle stick lowered the set point or less from
slow side
OFF
To Next Page
Loading...
