(4) Rudder exponential
default: -60% (F3C-AVCS), -40% (F3C-Normal), -20% (3D-
AVCS), -20% (3D-Normal)
ranges:
-100%
〜
+100%
It sets the control feeling of the rudder control.
Decreasing the rate to minus, the rudder control is
to be soften, and is to be quick when the value is
increased to plus side. Pushing the data+ or – key,
the value is changed.
(5) Rudder delay mode
default:
Function
It selects the rudder delay mode either Function
or Constant. The Function mode has the rudder
control is to be soften. The Constant mode has the
linear and quick motion of the rudder control. Se-
lect by pilot preference.
(6) Control delay In
default:
F3C=12, 3D=15
ranges:
0
〜
20
It sets the rudder control delay at moving to right
or left from neutral side. It can adjusts left and
right individually. Adding the value, the control
feeling is to be mild. Pushing data+ or – key, the
value is changed.
(7) Control delay Out
default:
F3C=10, 3D=12
ranges:
0
〜
20
It sets the rudder control delay at moving to neu-
tral from right or left side. It can adjusts left and
right individually. Adding the value, the control
feeling is to be mild. Pushing data+ or – key, the
value is changed.
(8) Stop delay
default:
120%
ranges:
100%
〜
400%
It sets the rudder delay at the tail stop motion. It
improves the tail stop bounce to adjust the value.
Pushing the data+ or – key, the value is changed.
(9) Gyro working mode
default:
CMT
It selects the gyro working mode either CMT,
Normal or AVCS. The CMT mode can select the
AVCS or Normal mode by gyro gain channel. The
Normal mode is always worked as Normal mode,
AVCS is always AVCS mode. Pushing the data+
or – key, the mode is changed.
To Next Page
Loading...
