(10) Pirouette speed
default:
450 deg/sec (F3C), 720 deg/sec (3D)
ranges:
100
〜
999 deg/sec
It adjusts the pirouette speed by the rudder con-
trol. The default value are set 450 deg/sec on F3C
mode, 720 deg/sec on 3D mode at rudder through
is 100 %. The below the line shows the actual pir-
ouette speed by rudder control. When this value
exceeds 1200 deg/sec, the gyro is out of control,
the pirouette speed is to be very quick and may be
dangerous situation. Pushing the data+ or – key,
the value is changed.
(11) Gain change up delay
default: 12
ranges: 1
〜
50
It sets the delay of the gyro gain changed from
low to high, the condition represents from idle up
to hovering. Increasing this value may cure if the
tail hunting is taken place at idle up to hovering.
Pushing data+ or – key, the value is changed.
(12) Gain change down delay
default: 3
ranges: 1
〜
50
It sets the delay of the gyro gain changed from
high to low, the condition represents from hover-
ing to idle up. Decreasing this value may cure if
the tail hunting is taken place at hovering to idle
up. Pushing data+ or – key, the value is changed.
(13) Rudder histeresis
default: 6 uS
ranges: 0
〜
50 uS
It adjusts the rudder stick null ranges. Pushing
data+ or – key, the value is changed.
(14) Gain tracking
default: 0 %
ranges: -20%
〜
+20%
It adjusts the gyro holding feeling at left and right
pirouette. Pushing data+ or – key, the value is
changed.
(15) F/F mixing
(S.Bus connection only)
default: off
It selects the F/F (Feed Forward) mixing active. It
helps the gyro operation to add the pitch to rudder
mixing prior to the gyro operation and improves
the gyro performance.
GY701 installs the pitch-> rudder mixing internal-
ly. The swash signal are mixed at the swash mode
helicopter. The correct F/F mixing is achieved
by individual pitch signal is to be input to the
To Next Page
Loading...
