FUTABA T10PX - Page 35

35
Receiver
* Even with the same receiver, if you change
the system, be sure to link with the receiver
and power cycle the receiver.
Tap the system to be set from F-4G, T-
FHSS SR, T-FHSS, S-FHSS or Mini-Z.
Tap the Ch.1(Steering ) Tap the SR mode
"Please link receiver again"
is display
2
In "Receiver", select and tap the
system to be set from systems.
The confirmation screen will be
displayed. To execute, tap [Yes] to
hear an electronic sound and finish
setting. To cancel, select [No] and
touch it. If you change the system,
be sure to link it with the receiver
and turn the power on again.
3
For the F-4G system, tapped [Analog Servo] [Digital Servo] [SR mode] in the receiver
setting "Response" and make changes. SR mode require their own dedicated servos.
The display changes when the mode is changed.
When using normal servo or ESC, set the Digital servo or Analog servo.
Note:
In SR mode ON, normal servo, ESC, and standard gyro will not operate.
4
Bring the transmitter and receiver within 50 cm of each other (antennas do not touch)
and turn on the receiver power.
5
Touch [Link] on the transmitter T10PX screen, you will hear a chime sound and T10PX
will enter the link mode for 20 seconds.
When using SR
servo for steering
When using battery fail-safe, set the
Battery Fail-safe Voltage in the "Fail-
safe" in the "Linkage menu". And link
again.