FUTABA T10PX - Compatibility with HPS-CT701 Servos; Compatibility with MC971 CR; MC971 CR Torque Function Requirements; TrimDial Function for Linkage Menu Settings

8
After opening the box, rst check if the contents conform to the following. The
contents depend on the set as shown below.
Set Contents
- If any of the set contents are missing, or you have any questions, please contact your dealer.
Transmitter / Receiver T10PX / R404SBS or R404SBS-E
Miscellaneous
Dry battery holder
*Installed in transmitter.
*Some sets do not have a Dry battery holder. Contents by set is differ-
ent. Also, the contents of the set will change.
Wheel offset adapter two size (APA)
APA Mounting screws
*Spare screws are also included
Wheel adapter 32 deg
Wheel Angle spacer 5 deg
Large diameter steering wheel
Trigger guard (Lx1
/ Rx1)
Grip rubber x1
Blind paddle x2
Hex wrench
Short manual
Always use only genuine Futaba transmitters, receivers, servos, ESCs (electronic speed controls), batter-
ies and other optional accessories.
Futaba will not be responsible for problems caused by the use of other than Futaba genuine parts. Use the parts specified in the in-
struction manual and catalog.
In addition, the Fail-safe Unit cannot be used because the system is different. Use the fail-safe function of
the transmitter.
*Some sets do not have a receiver/servo. Contents by
set is different. Also, the contents of the set will change.
The R404SBS-E receiver is for electric. Do not use for the gas powered models.
Specifications
*Specifications and ratings are subject to change without prior notice.
Transmitter T10PX
Wheel system, 10 channels (F-4G System), 7 channels (SFHSS System), 4 channels (TFHSS-SR, T-FHSS systems)
-Transmitting frequencies 2.4GHz band /- Transmitting RF power output: 100 mW EIRP
-Futaba F-4G/T-FHSS SR/T-FHSS/MINI-Z T-FHSS/S-FHSS
-Transmitting antenna 1/2
λ
dipole
-4.3 inch backlighted color TFT liquid crystal touch panel.
*When you turn on your 10PX, bright dots may appear on your screen display. Your display contains an extremely large number of TFT
and is manufactured using high-precision technology. Any bright dots that may appear on your display are intrinsic of the TFT manu-
facturing technology.
Receiver R404SBS / R404SBS-E
-Receiving frequency: 2.4GHz band /- Telemetry Receiver RF power output: 2.2 mW EIRP
-Power requirement: 3.7 V~7.4 V battery (Dry cell battery cannot be used.)
-System: F-4G system/S.BUS2 system
-Size: R404SBS---1.00x0.81x0.42" 25.5x20.7x10.6 mm
R404SBS-E---1.00x0.81x0.42"(include antenna 1.20") 25.5x20.7x10.6 mm(include antenna 30.5 mm)
-Weight : R404SBS---0.2 oz. (5.7 g) / R404SBS-E---0.25 oz. (7.2 g)