NOTE:
The Care Touch Blood Glucose and ß-ketone Monitoring System
should only be used with Care Touch Test Strips. Using other test
strips with this monitoring system may produce inaccurate results
SETTING THE METER
Before using your meter for the first time or if you change the meter
battery, you should check and update these settings.
Entering the Setting Mode (a)
Start with the meter off (no test strip inserted). Press SET (S).
1. Setting the date
The sequence of the date setting is: YEAR → MONTH → DAY. With
the YEAR/MONTH/DAY flashing in sequence, press M button
(M) until the correct year/month/day appears. Press S.
2. Setting the time format
Press M to select the desired time format (12h or 24h). Press S.
3. Setting the time
With the Hour/Minute flashing in sequence, press M until the
correct hour/minute appears. Press S.
4. Setting the measuring unit
With the measuring unit flashing, press M to switch between mg/dL
or mmol/L. Press S.
5. Setting the buzzer
With the flashing, press M to switch between “On” and “Off”.
Press S.
6. Deleting the memory
With “dEL” and a “ ” symbol on the display, press M and select
5
To Next Page
Loading...
