“no” to keep the results in memory then press S to skip. To delete all the
results, press M and select “yes” to delete all memory records.
7. Setting the reminder alarm
The meter has four reminder alarms. The meter will display “OFF”
and “AL1 ”. If you don’t want to set an alarm, press S to skip this
step; or press M to select “On”, then press S. With the
hour/minute flashing in sequence, press M to select the correct
hour/minute. Press S and go to the next alarm setting.
NOTICE:
When the alarm beeps, press M to switch it off. Otherwise, it
will beep for 2 minutes then switch off.
8. Setting the backlight
The default setting for meter backlight ("BL") is set to ON.
Press M to switch between “On” and “OFF”. Press S.
Congratulations! You have completed all settings!
NOTE:
These parameters can ONLY be changed in the setting mode.
If the meter is idle for 3 minutes during the setting mode, it
will switch off automatically.
THE FOUR MEASURING MODES
The meter provides you with four modes for measuring: General,
AC, PC and QC. You can switch between each mode by:
1. Start with the meter switched off. Insert a test strip to turn on the
meter. The screen will display a flashing blood drop and “Gen”.
2. Press M button to switch between General, AC, and PC modes.
6
To Next Page
Loading...
