Reviewing Test Results
1. Press and release M.
“ ” will appear on the display. Press M again, and the first
reading you see is the last blood glucose or ß-ketone test
result along with date, time and the measurement mode.
2. Press M to recall the test results stored in the meter each time
you press. After the last test result, press M button again and the
meter will be turned off.
Reviewing Blood Glucose Day Average Results
1. Press and release M.
When “ ” appears on the display, keep pressing M for 3 seconds
until the flashing “DAY AVG” appears. Release M and then your
7-day average result measured in general mode will appear on
the display.
2. Press M to review 7-,14-, 21-, 28-, 60- and 90- day average
results stored in each measuring mode in the order of Gen, AC,
and then PC.
3. Exit the meter memory. Keep pressing the M button and the
meter will turn off after displaying the last test result.
NOTE:
Any time you wish to exit the memory, keep pressing M button
for 5 seconds or leave it without any action for 3 minutes. The
meter will switch off automatically.
Control solution results are NOT included in the day average.
14
To Next Page
Loading...