WC CAPELLA ENGLISH CDN 540 REV10.DOCX 16 CAPELLA
A change in set-up of the rear wheels will affect the center of
balance of your chair.
1. The farther you move the rear axles FORWARD, the
more likely it is that your chair will tip over backward.
2. Consult your doctor, nurse or therapist to find the best
rear axle set-up for your chair. Do not change the set-up
UNLESS you are sure you are not at risk to tip over.
3. Adjust the rear wheel locks after you make any change to
the rear axles.
a. If you fail to do so, the locks may not work.
b. Make sure wheel locks are embedded in tires at least
1/8 inch when locked.
REAR WHEEL LOCKS
WARNING
Rear wheel locks are NOT designed to slow or stop a moving
wheelchair. Use them only to keep the rear wheels from
rolling when your chair is at a complete stop.
1. NEVER use rear wheel locks to try to slow or stop your
chair when it is moving. Doing so may cause you to veer
out of control.
2. To keep the rear wheels from rolling, always set both rear
wheel locks when you transfer to or from your chair.
3. Low pressure in a rear tire may cause the wheel lock on
that side to slip and may allow the wheel to turn when you
do not expect it.
4. Make sure wheel locks are embed in tires at least 1/8
inch when locked. If you fail to do so, the locks may not
work.
To Next Page
Loading...
