WC CAPELLA ENGLISH CDN 540 REV10.DOCX 19 CAPELLA
HEIGHT ADJ. FLIP-BACK ARM
1. Engaging and Disengaging Flip-back Arm
a. To disengage, press and hold the release lever (C) while pulling up on the
arm body.
b. Flip the armrest back; it remains attached to the rear pivot mount.
c. To reattach move the armrest down into place.
d. Press down until the release lever (C) locks into the receiver (D).
2. Height Adjustment
a. Pull the release knob (B) out to disengage the ball pin.
b. Slide armrest pad up or down to desired height.
c. Release the release knob to lock the armpost.
d. Push arm pad to check that it is locked firmly into place.
To Next Page
Loading...
