DMC-40x0 Command Reference TC • 227
24
Begin not valid because no sequence
defined
102 No master axis defined for ECAM
25 Variable not given in IN command 103
Master axis modulus greater than
256∗EP value
28 S operand not valid 104
Not valid when axis performing
ECAM
29 Not valid during coordinated move 105 EB1 command must be given first
30 Sequence segment too short 106 Privilege violation
31
Total move distance in a sequence > 2
billion
110 No hall effect sensors detected
32 More than 511 segments in a sequence 111
Must be made brushless by BA
command
33
VP or CR commands cannot be mixed
with LI commands
112 BZ command timeout
41 Contouring record range error 113 No movement in BZ command
42 Contour data being sent too slowly 114 BZ command runaway
46 Gear axis both master and follower 119
Not valid for axis configured as
stepper
50 Not enough fields 133 Command not valid when locked
51 Question mark not valid 134
All motors must be in MO for this
command
52 Missing " or string too long 135 Motor must be in MO
53 Error in {} 136 Invalid Password
54 Question mark part of string 137 Invalid lock setting
55 Missing [ or [] 138 Passwords not identical
USAGE: DEFAULTS:
While Moving Yes Default Value ---
In a Program Yes Default Format 3.0
Not in a Program Yes
Controller Usage
ALL CONTROLLERS
USAGE:
_TC contains the error code
EXAMPLES:
GF32 Bad command
:?
TC
Tell error code
:001 Unrecognized command
To Next Page
Loading...
Need help?
General
