Galil Motion Control DMC-40x0 Series User Manual

DMC-40x0 Command Reference #AUTO • 37
#AUTO
FUNCTION: Subroutine to run automatically upon power up
DESCRIPTION:
#AUTO denotes code to run automatically when power is applied to the controller, or after the
controller is reset. When no host software is used with the controller, #AUTO and the BP
command are required to run an application program on the controller.
USAGE:
While Moving Yes
In a Program Yes
Command Line No
Controller Usage
ALL
RELATED COMMANDS:
BP Burn program
EN End program
EXAMPLES:
#AUTO ;' Move the x axis upon power up
PRX=1000 ;' Move 1000 counts
BGX ;' Begin Motion
AMX ;' Wait until motion is complete
EN ;' End program
NOTE: Use EN to end the routine

Galil Motion Control DMC-40x0 Series Specifications

General

Brand	Galil Motion Control
Model	DMC-40x0 Series
Category	Controller
Language	English