Gallagher W810 v2 - The Mode Select Switch

3E2364WeighScaleW810v2UserManual

 Page9

Themodeselectswitch
TheWeighScalecanoperateinthreeweighingmodesandasetupmode.
ThemodeselectswitchislocatedonthelefthandsideoftheWeighScale.

Themodeselectswitchhasfivepositions:  ,A,M,FandS.Immediately
afteryouturntheswitchtoanypositionexcept ,explanatoryinformationwill
displayonthelowerofthetwoWeighScalescreens.Theexplanatory
informationwilldisplayonlyforafewseconds;afteritdisappears,thescreen
displaysinformationrelevanttotheselectedoption.

ThispositionturnstheWeighScaleoff.
A
ThispositionselectsweighinginAutomaticmode.
YoucanalsostoreElectronicIDsandupdatetheWeighScale's
cross‐referencetablewhentherearenoloadbarsconnected.
M
ThispositionselectsweighinginManualmode.
Youcanalsorecordanimalinformation,withoutweighing,whenthere
arenoloadbarsconnected.
F
ThispositionselectsweighinginFinemode.Itisdesignedfor
static‐loadweighing..
S
Thispositionaccessesthesetupoptions.
