Gallagher W810 v2 - Installing the Loadbars; Installing the Weigh Scale

 3E2364WeighScaleW810v2UserManual

Page4

Installingtheloadbars
Toinstalltheloadbars,followthesesteps:
Note:Fittheloadbarsasperthemanufacturer'sinstructions.
1. Bolttheplatformtotheloadbars.
2. Ensuretheplatformisplacedonaflatandlevelsurface.Makesureitisnot
touchinganyrailsorgates.
3. Eitherbolttheloadbarstotheconcretepadorlocatethemonstudssetinto
theconcrete.Thiswillpreventtheplatformfrommovingduringthe
weighingsession.
4. ConnecttheloadbarcablestotheWeighScale.
Note:IfyouareusingnonGallagher,loadbarsensuretheloadbarsarecorrectly
calibrated.
InstallingtheWeighScale
TheWeighScalecanbeplacedonatabletopormountedontheWeighScale
bracketsupplied.
PositiontheWeighScale:
 clearoftheplatformtoensureitdoesnotinterferewiththeflowof
animalsduringtheweighingcycle
 withineasyreachoftheloadbarleads
 withineasyreachoftheoperator(formanualweighing),and
 inawell‐litarea